Furuno 2137S-BB, 2837S installation manual Wiring consideration, Standard Interconnection

2. WIRING

Wiring consideration

•To lessen the chance of picking up electrical interference, avoid where possible routing the signal cable near other onboard electrical equipment (radars, transmitting radio antennas, etc.) Also avoid running the cable in parallel with power cables. When crossing with other cable, the angle should be 90°to minimize the magnetic field coupling.

•The signal cable run between the antenna and processor units is available in lengths of 15 m (standard), 30 m and 50 m. Whatever length is used it must be unbroken; namely, no splicing allowed. Use the signal cable as short as possible to minimize attenuation of the signal.

•The radar should be connected to an emergency power source, as required by SOLAS II-1.

2.1Interconnection

Monitor unit

Antenna unit

POWER SUPPLY

UNIT PSU-007

220	VAC, 3φ, 60 Hz		-2.5
200	VAC, 3φ, 50 Hz
440	VAC, 3φ, 60 Hz		TPYCY
380	VAC, 3φ, 50 Hz
For HSC
220	VAC, 3φ, 50 Hz
220	VAC, 3φ, 60 Hz
440	VAC, 3φ, 60 Hz
110	VAC, 3φ,	*
		RU-5693
60 Hz		*
220	VAC, 3φ,
		RU-6522
50 Hz		*
440	VAC, 3φ,	RU-5466-1
50 Hz

DPYC-1.5

TPYCY-2.5

TB801

TB802

Junction Box

RJB-001**

RW-9600 15/30/40/50 m (Max.100 m)

Processor unit

DVI-D/D SINGLELINK, 5 m/10 m

DPYC-2.5

Control unit (RCU-014 or RCU-015)

100-230 VAC	XH10P-W-5P-A
	L=10/20/30m

		XH10P-W-6P L=1.5/10/20/30 m
Memory card I/F unit Junction Box
		DPYC-2.5
CU-200-FAR	RJB-001**

100-115 VAC/220-230 VAC

*: Not available for HSC

**: If the length of the antenna cable is more than 100m, use Junction box RJB-001. However, the maximum length is 300m.

: Cable requires fabrication

Control unit (RCU-016)

F1

F2

F3

F4

Standard Interconnection

2-1