Furuno 2137S-BB, 2837S Fixing the DVI-RGB conversion board, Connecting wires to the housing

4. INSTALLING OPTIONAL EQUIPMENT

	DVI-RGB
	Conversion board
J4	J9	J3 (Connect DVI cable at step 10.)

Fixing the DVI-RGB conversion board

6.Attach the 10-pin connector from J1 on the 03P9229A board to J9 on the DVI-RGB board.

7.Attach the connector assembly 03-2092 to J4 on the DVI-RGB conversion board.

8.Remove connector housing J615 from the 03P9342 board. Connect the cable from J3 on the 03P9229A board and the cable from J4 on the DVI-RGB conversion board to J615. After connection, attach J615 to the 03P9342 board.

To connect wires to the connector housing, use the terminal opener (supplied as installation materials) as shown below.

J615 Housing

1

2

BRN

RED

ORG

YEL	2Insert core
GRN

Terminal opener

1Press downward

�

�

Connecting wires to the housing

9.Connect the DVI cable to J3 on the DVI-RGB conversion board. Connect the end which does not have the ferrite core.

10.Pass an RGB cable (local supply) through the cable clamp and connect it to J2 on the 03P9229A board.

11.Pass the DVI cable through the cable clamp, laying the section with copper tape in the cable clamp.

12.Assemble the processor unit and connect the other end of the DVI cable to DVI-D port.

4-14