1. MOUNTING
1.5Processor Unit
Mounting considerations
When selecting a mounting location, keep in mind the following points:
•Locate the processor unit away from heat sources because of heat that can build up inside the cabinet.
•Locate the equipment away from places subject to water splash and rain.
•Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
•A magnetic compass will be affected if the processor unit is placed too close to the magnetic compass. Observe the compass safe distances on page ii to prevent deviation of a magnetic compass.
Mounting procedure
1. Fix the unit with four M6 bolts, or self- tapping screws.
385
370±1
#50
25
410 | 340±1 | 380 |
350±1 | 7 | |
|
Floor mounting or bulkhead mounting
Note: If you fix the unit, cable entry upside, never remove the screw M3x10 that joints the upper case assy. and lower case assy. of the processor unit.
Upper case assy. 
Lower case assy.
Screw
M3X10 
Never remove this screw.
