Furuno 2137S-BB, 2837S installation manual Processor Unit, Fabricating power cable Dpyc

2. WIRING

2.4Processor Unit

Four cables are terminated at the processor unit: the antenna unit cable, display unit cable, control unit cable and the power cable. Cables other than the power cable come with a connector preattached to them for connection to the processor unit. Fabricate the power cable as below. For the power cable, use DPYC-2.5 (Japan Industry Standard) or the equivalent.

Note: Pass the AC line through a double-contact breaker (shipyard supply).

Fabricating the power cable

1.Cut armor of the cable by 40 mm.

2.Cut vinyl sheath by 35 mm.

3.Remove insulation of wires by about 10 mm. Fix crimp-on lugs to the cores.

4.Peel paint of the armor by 40 mm.

5.Cover the end of armor with vinyl tape.

(a) DPYC-2.5

Armor

Approx. 40 mm

35 mm

(b)

Vinyl sheath

10 mm

(c)

40 mm: Peel paint.

(d)

Taping

Fabricating power cable DPYC

2-7