Furuno 2137S-BB Connection of cables, Cable XH10P-W-6P L=20/30M, XH10P-W-5P-A L=10/20/30M

2. WIRING

Connection of cables

The power cable is connected to the terminal board on the rear panel and the signal cable from the Monitor unit is connected to the DVI-D connector. Other cables are connected to the printed circuit board 03P9342.

Monitor unit			Power cable clamp
	*			Power cable terminal board
Network	DVI-D monitor
												Remove the
												protection cover.
											F70
											FUSE
			15			1
											F1
			DC/AC			2
												Control unit**
Power cable												Heading senor
												Speed log
												Navigator
	9	14	17	21	2	3	4	5	6	18	19	20
				φ 9		HDG			RSD
		ACK	φ 18.9
								8	28	24	24'φ 7	26
				1		7		GYRO	PSU004	VDR IN VDR OUT
				AIS		AD100

Memory Card IF unit

Cable clamp	Antenna unit	VDR OUT
GND terminal
		VDR IN
		Gyrocompass

AD-100

AIS

Processor unit

*: The connector side which EMI core is attached should be connected to the processor unit.

**: The configuration of optional cables between the processor unit and the control unit is as follows. Note that the cable fabrication for each end is different.

Control unit

150 mm

20/30 m 300 mm

Cable XH10P-W-6P L=20/30M

Processor unit

When the RCU-016 is installed, optional cable (XH10P-W-5P-A, L=10/20/30M) is required. Cable fabrication for each end is the same.

Control unit

150 mm

10/20/30 m

XH10P-W-5P-A L=10/20/30M

150 mm

Control unit

2-8