HP 16501A LOGIC, 16500C manual Special Displays in this chapter

Intermodule Measurements

To monitor the activity of two coprocessors in a target system

7Select Group Run from the upper right corner of the display.

After the measurement is complete, you can interleave the trace lists of both state analyzers to see the activity executed by both coprocessors during related clock cycles.

You can use a similar procedure if you have only one processor, but wish to monitor its activity with that of other system nodes, such as chip-select lines, I/O activity, or behavior of a watchdog timer. In some instances it may be easier to look at related activity with a timing analyzer.

See Also	“Special Displays” in this chapter.
	“To use a state analyzer to trigger timing analysis of a count-down on a set of
	data lines” in this chapter.

2–20