To run a diagnostic test on a drive:
1.Ensure the library is not in use.
2.Press the [MENU] button until the Main Menu displays.
3.Press the arrow buttons until the cursor underscores DIAGNOSTICS.
4.Press the [SELECT] button.
The panel displays the Main Diagnostics Menu.
5.Press the arrow buttons until the cursor underscores DRIVE DIAGNOSTICS.
6.Press the [SELECT] button.
The screen will display a list of installed drives.
7.Use the arrow buttons to highlight the desired drive.
8.Press the [SELECT] button.
The Diagnostics Drive Menu appears.
9.Press the arrow buttons until the cursor underscores the desired test. For a description of the available tests, see Table 12 on page 115.
10.Press the [SELECT] button.
If you selected MOUNT/DISMOUNT LOOP, an editing screen will appear:
a.Use the arrow buttons to enter the desired value. (The up arrow button increases the value; the down arrow button decreases the value.)
b.Press the [SELECT] button.
11.You will be prompted to confirm that you want the library in Maintenance Mode (offline) before beginning the test (ARE YOU SURE?). Confirm this by pressing the [SELECT] button. (You may press the [MENU] button to abort.)
12.Wait until the test is completed; the screen will display a message that either the test completed successfully or, if a problem occurred, the screen will display an error message and, in some cases, an FSC code.
116 Operating in Automated Mode | Chapter 4 |