Configuration3

This chapter describes how to configure the library and drives for operation.

Configuration requires you to:

1.Enable Auto Clean (if desired) by installing cleaning cartridges

2.Power on or reset the library

3.Enter library and drive configuration information

4.Send a client command to load library audit information into client memory

After power-on, the library automatically verifies and loads some configuration values, such as drive locations, Auto Clean status, capacity, and drive types. Before the library is fully operational, however, someone must enter the remaining configuration values.

Typically, your service representative will configure your library during installation, during firmware upgrade, or after drives are added. If you must change the library’s configuration, you may enter the values through the operator panel.

Note

You may need to consult with your systems administrator for

 

some information.

 

 

65