Setting the Network Gateway Address
A network gateway in a large network allows devices on one subnet to interface with devices on another subnet (see Setting the Subnet Mask Address on page 84). This
Note | Entering this address is optional. It sets up the gateway |
| connection between subnets, but it is applicable only when such |
| a connection exists and is necessary for library operation. |
| Consult with your systems administrator for additional |
| information. |
|
|
To set the network gateway address:
1.At the Network Config Menu, press an arrow button until the cursor underscores NETWORK GATEWAY.
2.Press the [SELECT] button. An editing screen appears.
3.On the editing screen:
a.Press the up and down arrow buttons to select a value for each three- digit field in the address.
b.Press the [SELECT] button to move right to the next field.
c.Press the [MENU] button to move left to the previous field.
4.Press the [SELECT] button from the
5.If you have already changed the library’s SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section.
If you have not changed the library’s SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus.
3 Chapter
Chapter 3 | Entering Configuration Data 83 |