Setting the IP Address

The system administrator might assign the library an IP address, which makes the library accessible through a network. This is a four-byte address that must be set with information obtained from the system administrator. The value set identifies the library and makes it accessible through a network.

An example of an IP address entry is 192.0.0.1

Note

To use the Web-Based Library Administrator, you must set the

 

library’s IP address at the operator panel.

 

 

To set the IP address:

1.At the Network Config Menu, press an arrow button until the cursor underscores LIBRARY NAME.

2.Press the [SELECT] button. An editing screen appears.

3.On the editing screen:

a.Use the up and down arrow buttons to select a value for each three- digit field in the address.

Note

Do not leave the first field equal to zero (000).

 

 

b.Use the [SELECT] button to move right to the next field.

c.Use the [MENU] button to move left to the previous field.

4.When the screen displays your desired setting, press the [SELECT] button from the right-most field to save the changes. You may press the [MENU] button from the left-most field to abort.

5.If you have already changed the library’s SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section.

If you have not changed the library’s SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus.

82 Entering Configuration Data

Chapter 3