Setting the Library Name
The system administrator might assign the library a name. The name is mapped to the IP address but does not affect operation. To set the library name:
1.At the Network Config menu, press an arrow button until the cursor underscores LIBRARY NAME.
2.Press the [SELECT] button. An editing screen appears.
3.On the editing screen:
a.Use the up and down arrow buttons to select a value for each character (field) in the name.
b.Use the [SELECT] button to move right to the next field.
c.Use the [MENU] button to move left to the previous field.
Note | Do not enter a library name longer than 30 characters. |
|
|
4.When the screen displays your desired setting, press the [SELECT] button twice to save the changes. You may press the [MENU] button from the left- most field to abort.
5.If you have already changed the library’s SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section.
If you have not changed the library’s SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus.
3 Chapter
Chapter 3 | Entering Configuration Data 81 |