Replacing supplies and parts
Carefully follow the guidelines in this section when replacing printer supplies or parts. The transfer unit, fuser, and pickup roller are printer parts designed to last the lifetime of the printer. However, if these parts become damaged, they should be replaced.
Locating supplies and parts
Supplies and parts are identified by labeling and blue plastic handles.
The following figure illustrates the location of each supply item and part.
Supply item and part locations
1fuser
2print cartridges
3transfer unit
4pickup roller
Supply replacement guidelines
To facilitate the replacement of supplies, keep the following guidelines in mind when setting up the printer.
●Sufficient space is required above and in the front of the printer for removing supplies.
●The printer should be located on a flat, sturdy surface.
For instructions on installing supplies, see the installation guides provided with each supply item or see more information for the HP Color LaserJet 3500 series printer at http://www.hp.com/support/clj3500 and for the HP Color LaserJet 3700 series printer at http://www.hp.com/support/clj3700.
CAUTION | |
| may cause problems requiring service that is not covered by the |
| service agreements. |
Changing print cartridges
When a print cartridge approaches the end of useful life, the control panel displays a message recommending that you order a replacement. The printer can continue to print using the current print cartridge until the control panel displays a message instructing you to replace the cartridge.
110 Chapter 7 Maintenance | ENWW |