| 3. | Press | to select CONFIGURE DEVICE. |
| 4. | Press | to highlight I/O. |
| 5. | Press | to select I/O. |
| 6. | Press | to highlight EIO 1. |
| 7. | Press | to select EIO 1. |
| 8. | Press | to highlight TCP/IP. |
| 9. | Press | to select TCP/IP. |
| 10. | Press | to select CONFIG METHOD. |
| 11. | Press | to highlight MANUAL. |
| 12. | Press | to select MANUAL. |
| 13. | Press | to highlight MANUAL SETTINGS. |
| 14. | Press | to select MANUAL SETTINGS. |
| 15. | Press | to highlight SUBNET MASK. |
| 16. | Press | to select SUBNET MASK. |
| The first of four sets of numbers is highlighted. Each set of numbers represents one byte of | ||
Note | |||
| information and has a range from 0 to 255. | ||
| 17. | Press the or arrow to increase or decrease the number for the first byte of the | |
|
| subnet mask. | |
| 18. | Press | to move to the next set of numbers. (Press to move to the previous set of |
|
| numbers.) | |
| 19. | Repeat steps 17 and 18 until the correct subnet mask is entered. | |
| 20. | Press | to save the subnet mask. |
| 21. | Press MENU to return to the Ready state. |
Setting the default gateway
1.Press MENU to enter the MENUS.
2.Press to highlight CONFIGURE DEVICE.
3.Press to select CONFIGURE DEVICE.
4.Press to highlight I/O.
5.Press to select I/O.
6.Press to highlight EIO 1.
7.Press to select EIO 1.
8.Press to highlight TCP/IP.
9.Press to select TCP/IP.
10.Press to select CONFIG METHOD.
11.Press to highlight MANUAL.
12.Press to select MANUAL.
13.Press to highlight MANUAL SETTINGS.
54 Chapter 3 I/O configuration | ENWW |