7. Rotate the blue side of the pickup roller until it clicks into place.
8. Replace Tray 2.
9.Turn the printer on. After a short time, the printer control panel might display the message NEW FUSER KIT.
10.If the message NEW FUSER KIT appears, go to step 11. If the message does not appear, you must reset the fuser count. See To reset the fuser count.
11.On the printer control panel, press 
to highlight YES, and then press 
to select it. The fuser count is reset and the printer is ready to use.
To reset the fuser count
1.Press MENU to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight RESETS.
5.Press 
to select RESETS.
6.Press 
to highlight RESET SUPPLIES.
7.Press 
to select RESET SUPPLIES.
8.Press 
to highlight NEW FUSER KIT.
9.Press 
to select NEW FUSER KIT.
ENWW | Replacing supplies and parts 125 |