Note
Note
14.Press 
to select MANUAL SETTINGS.
15.Press 
to highlight DEFAULT GATEWAY.
16.Press 
to select DEFAULT GATEWAY.
The first of four sets of numbers are the default settings. Each set of numbers represents one byte of information and has a range from 0 to 255.
17.Press the 
or 
arrow to increase or decrease the number for the first byte of the default gateway.
18.Press 
to move to the next set of numbers. (Press 
to move to the previous set of numbers.)
19.Repeat steps 17 and 18 until the correct subnet mask is entered.
20.Press 
to save the default gateway.
21.Press MENU to return to the Ready state.
Setting the syslog server
1.Press MENU to enter the MENUS.
2.Press 
to highlight CONFIGURE DEVICE.
3.Press 
to select CONFIGURE DEVICE.
4.Press 
to highlight I/O.
5.Press 
to select I/O.
6.Press 
to highlight EIO 1.
7.Press 
to select EIO 1.
8.Press 
to highlight TCP/IP.
9.Press 
to select TCP/IP.
10.Press 
to select CONFIG METHOD.
11.Press 
to highlight MANUAL.
12.Press 
to select MANUAL.
13.Press 
to highlight MANUAL SETTINGS.
14.Press 
to select MANUAL SETTINGS.
15.Press 
to highlight SYSLOG SERVER.
16.Press 
to select SYSLOG SERVER.
The first of four sets of numbers are the default settings. Each set of numbers represents one byte of information and has a range from 0 to 255.
17.Press the 
or 
arrow to increase or decrease the number for the first byte of the default gateway.
18.Press 
to move to the next set of numbers. (Press 
to move to the previous set of numbers.)
19.Repeat steps 17 and 18 until the correct subnet mask is entered.
20.Press 
to save the syslog server.
21.Press MENU to return to the Ready state.
ENWW | Network configuration 55 |