If the settings are not available from the software, set the custom paper size from the control panel:

1From the Printing Menu set￿%10(+)74'￿%7561/￿2#2'4￿;'5.

2From the Printing Menu, select inches or millimeters as the unit of measurement.

3From the Printing Menu, set the X dimension (the front edge of the paper) as shown in Figure 15. X can be 3 to 8.5 inches (76 to 216 mm).

4Set the Y dimension (the side edge of the paper) as shown in Figure 15. Y can be 5 to 14 inches (127 to 356 mm).

5If custom paper is loaded into Tray 1 and 64#;￿￿￿/1&'￿%#55'66', then set 64#;￿￿￿5+<'￿%7561/￿from the Paper Handling Menu in the printer’s control panel. See “Customizing Tray 1 Operation” on page 50.

If custom paper is loaded in the optional 500-sheet tray, be sure the paper size dial is set to Custom (page 29).

6In the software, select Custom as the paper size.

For example, if the custom paper is 8 by 10 inches (203 by 254 mm), set X=8 inches and Y=10 inches (X=203 millimeters and Y=254 millimeters).

The control panel must be set if the PCL 5e driver is used, or custom paper is loaded long-edge first (X is longer than Y).

EN

Chapter 2: Printing Tasks 47