HP LaserJet 4000N, 4000TN PCL or PS Font List, To print a PCL or PS font list:, Font, [Menu], [Item], [Select], Pitch/Point, Escape Sequence

PCL or PS Font List

Use the font lists to see which fonts are currently installed in the printer. (The font lists also show which fonts are resident on an optional hard disk or flash DIMM.)

To print a PCL or PS font list:

1Press [Menu] until +0(14/#6+10￿/'07 appears.

2Press [Item] until 24+06￿2%.￿(106￿.+56 or 24+06￿25￿(106￿.+56 appears.

3Press [Select] to print the font list.

The PS font list shows the PS fonts installed, and gives a sample of those fonts. The following describes the information that can be found on the PCL font list:

•Font gives the font names and samples.

•Pitch/Point indicates the pitch or point size of the font.

•Escape Sequence (a PCL programming command) is used to select the designated font. (See the legend at the bottom of the font list page.)

Note	For step-by-step instructions on using printer commands to select
	a font with DOS applications.
	•	Font # is the number used to select fonts from the printer’s control
		panel (not the software application). Do not confuse the font #
		with the font ID, described below. The number indicates the DIMM
		slot where the font is stored.
		•	SOFT: Downloaded fonts, which stay resident in the printer until
			other fonts are downloaded to replace them, or until the printer
		•	is turned off.
	•		INTERNAL: Fonts that permanently reside in the printer.
		Font ID is the number you assign to soft fonts when you download
		them through software.

96 Chapter 4: Problem Solving

EN