Configuration Menu (Continued)

Item

Values

Explanation

 

 

 

/12+'4￿/1&'￿56#0&

Determine how the mopier functions behave.

56#0&

'0*#0%'&

This item appears only when there is at least

 

1((

8 MB of memory or an optional hard disk is

 

installed.

 

 

 

 

56#0&: This option is available if there is

 

 

either a hard disk installed or a RAM disk

 

 

configured in memory. This option uses I/O

 

 

data stored in printer memory for generating

 

 

multiple original prints. (All copies will print at

 

 

the same speed as the first copy.)

 

 

'0*#0%'&: This option is available if there is a

 

 

hard disk installed and at least 8 MB of memory.

 

 

This option uses engine video data for printing

 

 

multiple original prints and should print all

 

 

copies after the first at the printer’s maximum

 

 

speed.

 

 

1((: Disables the mopier functions. (The

 

 

printer will not spool any jobs to the hard disk.)

 

 

When the mopier mode is changed, any

 

 

downloaded resources (such as fonts or

 

 

macros) will need to be downloaded again,

 

 

unless they are stored on an optional hard disk

 

 

or flash DIMM.

 

 

 

4#/￿&+5-￿1((

1((

Determine how the RAM disk is configured.

 

10

This item appears only if there is no optional

 

#761

hard disk installed and the printer has at least

 

8 MB of memory.

 

 

 

 

1((: The RAM disk is disabled.

 

 

10: The RAM disk is enabled. Configure the

 

 

amount of memory to be used through the

 

 

following item: 4#/￿&+5-￿5+<'.

 

 

Note

 

 

If the setting is changed from 1(( to 10 or from

 

 

1(( to #761, the printer will automatically

 

 

reinitialize when it becomes idle.

 

 

 

4#/￿&+5-￿5+<'￿

￿- and up

Determine the size of the RAM disk. This item

ZZZ-

(This value

appears if 4#/￿&+5-=10￿or #761.

Press [-Value+]to change settings by

 

depends on the

 

amount of

increments of 100.

 

installed

Note

 

memory.)

 

This setting cannot be changed if 4#/￿&+5-￿

 

 

 

 

#761. Changing this value will cause the

 

 

printer to reinitialize when it becomes idle.

B-14 Control Panel Menus

EN