HP 8000N, 8000DN manual Problem Solving 171 Printer Messages

Chapter 5 Problem Solving		171
Printer Messages	(continued)
Message	Explanation or Recommended Action
EIO n	Wait for the message to disappear (approximately 5 minutes). If the
INITIALIZING	printer EIO card is operating correctly and communicating with the
alternates with	network, this message disappears after approximately one minute
DO NOT POWER OFF	and no action is required.
	If the EIO card is unable to communicate with the network, this
	message remains for five minutes and then disappears. In this case
	the printer is not communicating with the network (even though the
	message is no longer present). The problem may be a bad EIO card,
	a bad cable or connection on the network, or a network problem.
	Contact your network administrator.
EIO n DISK	The disk accessory card takes a long time to initialize. The first
SPINNING UP	parameter is the accessory slot number for this accessory card.
ENV FEEDER LOAD	Load the requested envelope type and size into the envelope feeder.
[TYPE] [SIZE]	Make sure the envelope size and type are set correctly from the
	Paper Handling Menu in the printer’s control panel (page 283).
	Press GO if the desired envelope is already loaded in the feeder.
	Press - VALUE + to scroll through the available types and sizes. Press
	SELECT to accept the alternate type or size.
EXTERNAL DEVICE	When an external paper handling device is connected to the printer,
INITIALIZING	it must have 10 seconds to initialize after boot or after coming out of
	Power Save mode.

Understanding Printer Messages