HP BER 718 37718A manual Start the Jitter Transfer Measurement

Making Measurements

Measuring Jitter Transfer

HOW TO:	Start the Jitter Transfer Measurement
	The Jitter Transfer measurement must be started within 10 minutes of
NOTE
	the completion of calibration.
	1 After the CALIBRATION is completed, remove the back to back
		connection from the DSn or SONET or optical interfaces.
		If the measurement is to be made at a network equipment monitor
		point, choose		MONITOR		on the DSn or SONET RECEIVE display
		before making		the jitter		transfer measurement.
	2 Choose MODE						on the TRANSMIT		display and
					MEASURE			JITTER
		press RUN/STOP			.
		The measurement’s progress can be monitored on the TRANSMIT
		display. At the end of the test the graph can be viewed on the RESULTS
		JITTER	display.

95