| Selecting Test Features |
|
| Adding Pointer Adjustments |
|
| The following conditions apply for pointer sequence generation: | |
NOTE | ||
| The sequences can only be applied to the SPE pointer when the SPE does | |
| not contain a VT structure, otherwise it is applied to the VT pointer. | |
| Pointer sequence generation is not available when a frequency offset is | |
| being applied to the Line Rate. |
|
| The following figure gives an example of a | |
| ||
| Sequence. |
|
| T1.105 A4 and A5, |
|
| No Pointer | Start of Next |
| Adjustment | |
| Pointer Adjustment |
|
87 | 3 |
|
Pointer Sequence | Description |
|
|
T1.105 A1 SINGLE | Periodic Single adjustments, all of the same polarity which is |
selectable. Separation between pointer adjustments is fixed at | |
| approximately 30 seconds. |
|
|
T1.105 A2 BURST OF 3 | Periodic bursts of 3 adjustments, all of the same polarity which is |
selectable. The interval between bursts is fixed at approximately 30 | |
| seconds. The interval between adjustments within a burst is set to |
| the minimum. |
|
|
57