Chapter 14
•Solution 4: Turn off the product, the computer, and the router.
•Solution 5: Try to access the Embedded Web Server on the product
Troubleshooting
Solution 1: Check the cable connection
Solution: Check the following cables to ensure they are connected properly.
•Cables between the product and the hub or router
•Cables between the hub or router and your computer
•Cables to and from your modem or product Internet connection (if applicable)
Cause: The cables were not connected properly.
If this did not solve the issue, try the next solution.
Solution 2: Check the LAN card set up
Solution: Make sure that your LAN card is set up properly.
To check your LAN card (Windows Vista)
1.On the Windows taskbar, click Start, Computer, and then click Properties.
2.Click Device Manager.
3.Make sure your card shows up under Network Adapters.
4.Refer to the documentation that came with your card.
To check your LAN card (Windows XP)
1.
2.In the System Properties dialog box, click the Hardware tab.
3.Click Device Manager.
4.Make sure your card shows up under Network Adapters.
5.Refer to the documentation that came with your card.
Cause: Your computer's Local Area Network card (LAN card) was not set up properly.
If this did not solve the issue, try the next solution.
Solution 3: Check the active network connection
Solution: Check to see if you have an active network connection.
To see if you have an active network connection
▲Check the two Ethernet indicator lights on the top and bottom of the
a. Top light: If this light is a solid green, the product is properly connected to the network, and communications have been established. If the top light is off, there is no network connection.
b. Bottom light: This yellow light flashes when data is being sent or received by the product over the network.
150 Troubleshooting