Troubleshooting
Chapter 14
3.Open the ink cartridge access door by lifting from the front right of the product, until the door locks into place.
The print carriage moves to the center of the product.
NOTE: Wait until the print carriage stops moving before proceeding.
4.Locate the sensor inside the product.
The sensor is a square, black plastic part slightly larger than a pencil eraser, just to the left of the print carriage.
5.Wipe the sensor with a dry swab or
6.Close the ink cartridge access door, and check if the error message has been resolved.
7.If you still receive the error message, turn the product off, and then on again.
Cause: Ink might have built up and covered the sensor.
If this did not solve the issue, try the next solution.
Solution 2: Clean the sensor windows on the ink cartridges
Solution: Clean the window on all of the ink cartridges.
290 Troubleshooting