HP C6300 37

Chapter 4

setup Finish

d. Press the down arrow button until Ad Hoc is highlighted, and then press OK.

e. Press the down arrow button until Yes, my network uses WEP encryption is highlighted, and then press OK. The visual keyboard displays.

If you do not want to use WEP encryption, press the down arrow button until No, my network does not use encryption is highlighted, and then press OK. Go to step 7.

6.If prompted, enter your WEP key as follows. Otherwise go to step 7.

a. Use the arrow buttons to highlight a letter or number on the visual keyboard, and then press OK to select it.

NOTE: You must enter the exact uppercase (capital) and lowercase (small) letters. Otherwise, the wireless connection will fail.

b. When you are finished entering the WEP key, use the arrow buttons to highlight Done on the visual keyboard.

7.Press OK again to confirm.

The product will attempt to connect to the SSID. If a message says you entered an invalid WEP key, check the key you wrote down for your new network, follow the prompts to correct the WEP key, and then try again.

8.When the product connects successfully to the network, go to your computer to install the software.

NOTE: You can print the Wireless Network Test report at the end of a successful Wireless Setup Wizard connection which can help identify any potential future issues with the network setup.