![](/images/new-backgrounds/1315811/31581159x1.webp)
Table 3-6 Computer Setup—Advanced (for advanced users) (continued)
VGA Configuration | Displayed only if there is an |
| controller will be the “boot” or primary VGA controller. |
|
|
AMT Configuration | Allows you to set: |
| ● AMT (enable/disable). Allows you to enable or disable functions of the embedded |
| Management Engine (ME) such as Active Management Technology (AMT). If set to disable, |
| the Management Engine is set to a temporarily disabled state and will not provide functions |
| beyond necessary system configuration. Default is enabled. |
| ● Unconfigure AMT/ME (enable/disable). Allows you to unconfigure any provisioned |
| management settings for AMT. The AMT settings are restored to factory defaults. This |
| feature should be used with caution as AMT will not be able to provide any set AMT |
| management functions once unconfigured. Default is disabled. |
| ● Hide Unconfigure ME Confirmation Prompt (enable/disable). Allows you to set the system to |
| not display the confirmation to unconfigure ME. |
| ● Watchdog Timer (enable/disable). Allows you to set amount of time for a operating system |
| and BIOS watchdog alert to be sent if the timers are not deactivated. BIOS watchdog is |
| deactivated by BIOS and would indicate that a halt occurred during execution if the alert is |
| sent to the management console. An operating system alert is deactivated by the operating |
| system image and would indicate that a hang occurred during its initialization. Default is |
| enabled. |
|
|
Recovering the Configuration Settings
This method of recovery requires that you first perform the Save to Removable Media command with the Computer Setup (F10) Utility before Restore is needed. (See Computer
NOTE: It is recommended that you save any modified computer configuration settings to a USB flash media device and save the device for possible future use.
To restore the configuration, insert the USB flash media device with the saved configuration and perform the Restore from Removable Media command with the Computer Setup (F10) Utility. (See Computer
Recovering the Configuration Settings 23