HP Pro 4300 manual Memory

Models: Pro 4300

1 162
Download 162 pages 51.63 Kb
Page 52
Image 52

Memory

Memory modules are located on the right side of the computer (viewed from behind) under the memory access panel. The computer has two memory slots.

Figure 6-18Memory module location

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3- SDRAM) small outline dual inline memory modules (SODIMMs).

The memory sockets on the system board can be populated with up to two industry-standard SODIMMs. These memory sockets are populated with at least one preinstalled SODIMM. To achieve the maximum memory support, you can populate the system board with up to 16 GB of memory.

For proper system operation, the SODIMMs must be:

industry-standard 204-pin

unbuffered non-ECC PC3-10600 DDR3-1600 MHz-compliant

1.5 volt DDR3-SDRAM SODIMMs

The DDR3-SDRAM SODIMMs must also:

support CAS latency 9 DDR3 1600 MHz (9-9-9 timing)

contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification In addition, the computer supports:

512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies

single-sided and double-sided SODIMMS

SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not supported

NOTE: The system will not operate properly if you install unsupported SODIMMs.

Memory 45

Page 52
Image 52
HP Pro 4300 manual Memory