
4.Lower the output tray.
5.Pull out the extension on the output tray.
NOTE: For media longer than 11 inches (279 mm), pull the extension out to the maximum extended position.
To load Tray 2
1.Pull the tray out of the device by grasping the front of the tray.
2.Slide the media guides out to the widest setting.
3.Insert the media
NOTE: Do not load paper while the device is printing.
4.Gently reinsert the tray.
5.Pull out the extension on the output tray.
NOTE: For media longer than 11 inches (279 mm), pull the extension out to the maximum extended position.
Configure trays
NOTE: Tray 2 is sold as an accessory. For ordering information, see Accessories.
To configure trays, you must have Tray 2 installed and turned on in the printer driver.
Configure trays | 23 |