HP UX 11i v2 manual Accidental Activation of an Instant Capacity, Cell Board, 102

Cell Board Instant Capacity

Accidental Activation of an Instant Capacity Cell Board

	Accidental Activation of an Instant Capacity
	Cell Board
	If you inadvertently activate an Instant Capacity cell board, you can
	de-activate it by following this two step procedure:
Step	1. Set the cell board’s use-on-next-bootflag to “n” (no) using the
	parmodify command
Step	2. Perform a reboot of the nPartition
Example 6-4	De-activating a cell board in cabinet 0, slot 5, nPartition 3
	For example, changing the use-on-next-bootflag to “n” on the Instant
	Capacity cell board in cabinet 0, slot 5, in nPartition 3 can be
	accomplished via the following command:
	/usr/sbin/parmodify -p 3 -m 0/5::n:
	The “n” in the above command line sets the cell board’s
	use-on-next-bootflag to “no” and causes the cell board to not
	participate in the nPartition when it is booted.
	See the HP System Partitions Guide for details about adding and
	configuring cells in nPartitions.

102 Chapter 6