HP UX 11i v2 44

Installing and Uninstalling Instant Capacity Software

Installing Instant Capacity Software

	Installing Instant Capacity Software
Factory Integrated	You do not need to install the Instant Capacity software if your
Systems	processors and software were ordered with your HP enterprise server.
	The Instant Capacity software was already installed by HP prior to
	delivery. You can use the following command to verify that the software
	is installed and configured:
	/usr/sbin/swverify B9073BA
	You should see Verification succeeded. in the output of the
	swverify command.

IMPORTANT	The Instant Capacity software is automatically installed when the
	HP-UX 11i v2 or 11i v1 Operating Environment (OE) is installed. If any
	partition in the system has version B.07.x software installed, then all
	partitions in the system with Instant Capacity software must be running
	version B.07.x software. That is, there cannot be a mix of different
	versions of the Instant Capacity software in the same system. See
	“Upgrading to Instant Capacity versions B.06.x or B.07.x Software” on
	page 122 for details of upgrading the software from a version previous to
	B.07.x.

For HP-UX you should not need to install the Instant Capacity software; however, if you do, it is available from the following media/locations:

•HP software depot (HP web site: http://www.hp.com/go/softwaredepot)

•May 2005 HP-UX 11i v2 Operating Environment (OE) media

•May 2005 HP-UX 11i v2 Applications Software media

•September 2005 HP-UX 11i v1 Operating Environment (OE) media

•September 2005 HP-UX 11i v1 Applications Software media

The following instructions can be used to install versions B.07.x:

Chapter 3