HP UX IPFilter Software manual Command Line to Invoke the Advisor, Command line is

Figure 13 Steps in Using the Advisor
				Make
				sugg ested
				chang es
	Build	One or more	HP Calip er	Gain better
Start		HP Calip er		und erstandin g	End
	appl ication	performanc e	Advisor	of appl ication
		runs		performanc e
				Make
				sugg ested
				performanc e
				runs

To use the HP Caliper Advisor, you perform these steps:

1.Build the application with an initial set of compiler/linker options.

2.Make one or more HP Caliper measurement runs on the application, keeping track of the names of the databases where the performance data is kept.

3.Run the Advisor, using the databases containing the performance data. The advice is output (printed) in a report file from the Advisor, with this kind of information:

•Explanations of the performance problems indicated by the performance data collected

•Suggestions for changes to the application code, compiler options, linker options, and so forth for improving the identified performance problems

•Suggestions for additional performance runs to further investigate the identified or other potential performance problems

4.Based on the advice you receive from the Advisor, do either of the following:

•Change the application code and/or build options and start over at step 1 with the revised application and a new set of performance measurements and databases.

or:

•Make new performance measurements in step 2, saving the data to a new database, and rerun the Advisor.

5.Continue making adjustments as long as you keep receiving meaningful data.

Command Line to Invoke the Advisor

The command line is:

$ caliper advise [advise_options] [database_list]

where advise_options are:

--advice-classes [all][[general][:cpu][:memory][:io][:system]] --advice-cutoff min-index[,min-count[,max-count]] --advice-details [all][[description][:improvement][:measurement]

[:explanation][:rule]]

--analysis-focus [executable:]nameall[,[executable:]name],...

Command Line to Invoke the Advisor 79