SECTION 3—SAFETY INSPECTION/TROUBLESHOOTING

Check that the wheel lock pivot points are free of wear and looseness.

Inspect seat and back for loose or broken hardware.

Inspect seat positioning strap for any signs of wear. Ensure buckle latches. Verify hardware that attaches strap to frame is secure and undamaged. Replace if necessary.

Inspect back cane hand grips for wear/looseness/deterioration.

Adjust front casters/forks bearing system if wheel wobbles noticeably or binds to a stop.

Ensure wheel bearings are clean and free of moisture.

Check headtube locknuts for tightness.

Ensure casters are free of debris.

Make sure detent balls of the quick‐release pin are fully released before operating the wheelchair.

The detent balls MUST be protruding past the top of the seat plate assembly for a positive lock.

Keep detent balls clean.

Inspect/Adjust Periodically

Inspect frame and crossbraces for loose or missing hardware.

Inspect for bent frame or crossbraces.

Check that wheel locks are easy to engage.

Inspect seat and backs for rips and sagging.

Check that there is no excessive side movement or binding in the rear wheels when lifted and spun.

Inspect handrims for signs of rough edges or peeling.

Adjust front casters/forks bearing system if wheel wobbles noticeably or binds to a stop.

Ensure wheel bearings are clean and free of moisture.

Inspect casters for cracks and wear.

Clean upholstery and armrests.

Check that all labels are present and legible. Replace if necessary.

Ensure casters are free of debris.

Make sure detent balls of the quick‐release pin are fully released before operating the wheelchair.

The detent balls MUST be protruding past the top of the seat plate assembly for a positive lock.

Keep detent balls clean.

Orbit

24

Part No. 1073955

Page 24
Image 24
Invacare 1073955 manual Inspect/Adjust Periodically