SECTION 13—OPTIONS

SECTION 13—OPTIONS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

RECLINER MODELS ONLY - If the ventilator, ventilator battery, or ventilator tray option is removed, the recliner limit stop MUST be installed before operation of the wheelchair. Otherwise, injury or damage may result.

Using the Ventilator Tray

NOTE: For this procedure, refer to FIGURE 13.1.

1.Position all four straps to the outside of the ventilator tray.

2.Position the ventilator battery in the front portion of the ventilator tray.

3.Secure the two straps around the top of the ventilator battery and clip together.

4.Position the ventilator in the rear portion of the ventilator tray.

5.Secure the two straps around the top of the ventilator and clip together.

6.Adjust the slides, located in the middle of each strap, up or down to increase or decrease length. (See Detail “A”).

7.Securely tighten the straps around the battery and ventilator by pulling the ends of the straps through the rear portion of each buckle. (See Detail “B”).

 

DETAIL “A”

Ventilator

See

 

Battery

 

 

DETAIL “B”

 

Strap

 

 

 

See

 

 

 

DETAIL “A”

Slide

 

Buckle

Rear

 

Portion

 

 

 

DETAIL “B”

 

 

Rear

Strap

Front

 

 

 

Portion

 

 

 

Portion

 

of Buckle

 

 

 

Ventilator

 

 

 

 

 

 

Tray

Slide

FIGURE 13.1 Using the Ventilator Tray

Orbit

82

Part No. 1073955

Page 82
Image 82
Invacare 1073955 manual Options, Using the Ventilator Tray