SECTION
CAUTION
When reattaching back assembly, DO NOT OVERTIGHTEN! Back will not fold down properly. Tighten hardware until snug.
10.Reattach back assembly to the back angle bracket with the existing mounting screws, spacers, washers, and locknuts. DO NOT overtighten. Wheelchair will not fold properly. Tighten until a snug fit is provided.
11.Reinstall the locking mechanisms in the back canes. Refer to Replacing/Repositioning the Locking Mechanism in the Cantilever Arm on page 50.
|
| Back Assembly |
Coved | Set |
|
Screw |
| |
Spacer |
| |
|
| |
| Spreader |
|
| Bar |
|
Mounting |
| Coved |
| Spacer | |
Screw |
| |
|
| |
| Locknuts | Mounting |
| Screw | |
|
| |
Washers |
|
|
| Back Angle Bracket |
|
FIGURE 7.5 Removing/Installing the Spreader Bar
Folding/Unfolding the Back Canes
NOTE: For this procedure, refer to FIGURE 7.6
1.To fold back canes, lift up on actuator pins and fold back canes forward.
2.To unfold back canes, pull back canes up until actuator pins are locked in place.
NOTE: Actuator pins are locked in place when an audible click is heard.
