SECTION
Removing Adjustable Angle Stroller Handles
1.Remove the two mounting screws that secure the adjustable height stroller handle to the back canes.
2.Remove the adjustable angle stroller handle from the back cane.
3.Install back cane grips and/or plug buttons.
Mounting | Stroller Handle |
Screw |
|
| Locknuts |
NOTE: Back cane grips and | Mounting |
Screw | |
plug buttons not shown for | Back |
clarity. | Canes |
FIGURE 7.3 Installing Adjustable Angle Stroller Handles - Removing Adjustable Angle Stroller
Handles
Adjusting Adjustable Angle Stroller Handles
NOTE: For this procedure, refer to FIGURE 7.4 on page 55.
NOTE: Stroller handles adjust in the same manner for recliner and non‐recliner models.
1.Flip both release levers to the unlocked position.
2.Adjust stroller handle to desired height.
3.Flip both release levers to the locked position.
4.Push down on stroller handle to ensure release levers hold the desired position of the stroller handle.
5.If release levers DO NOT hold the position, tighten the release lever by performing the following:
A.Flip release lever to the unlocked position.
B.Rotate thumbscrew clockwise one revolution.
NOTE: When tightening the release lever, the release lever must be able to close completely into the locked position. Otherwise, the release levers will not hold the desired angle
C. Flip release lever to locked position.
NOTE: If the release lever does not close completely into the locked position, rotate the thumbscrew counterclockwise 1/2 revolution.
D.Repeat STEPS A‐C for opposite release lever.
E.Push down on stroller handle to ensure release levers hold the desired position of the stroller handle.
F.Repeat STEPS A‐E until release levers hold the position.
