SECTION 5—FRONT RIGGINGS

SECTION 5—FRONT RIGGINGS

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 5.1.

Installing Front Riggings

1.Turn the front rigging assembly to the side (open front rigging is perpendicular to wheelchair).

2.Install the hinge plates on the front rigging assembly onto the hinge pins on the wheelchair frame.

3.Push the front rigging assembly towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat this procedure for the other front rigging assembly.

5.To release the front rigging, push the front rigging release lever inward, rotate front rigging outward.

Footrest

Mounting

Pin

Mounting

Footrest

Tube

NOTE: All swingaway style footrests are installed the same way. Only one style of footrest is shown for clarity

FIGURE 5.1 Installing/Removing Front

Riggings

Removing Front Riggings

1.Push the front rigging release lever inward

2.Rotate swingaway front rigging assembly outward.

3.Lift the swingaway front rigging assembly off the hinge pins.

Orbit

30

Part No. 1073955

Page 30
Image 30
Invacare 1073955 manual Installing/Removing Front Riggings, Installing Front Riggings