Invacare 1073955 manual Installing Fixed Height Stroller Handles

SECTION 7—SEAT AND BACK

Installing Fixed Height Stroller Handles

NOTE: For this procedure, refer to FIGURE 7.2.

1.Remove the back cane grip and plug button from the back cane.

2.Slide the stroller handle into the back cane.

3.Align the mounting holes of the stroller handle and the back cane.

4.Press the button on the quick‐release pin and insert the quick‐release pin through the back cane and stroller handle.

5.Repeat STEPS 1‐4 for the opposite stroller handle.

6.Pull on the stroller handle to make sure it is locked securely in place

Plug Button

(STEP 1) Back Cane

Grip (STEP 1)

Stroller

Handle

Button

Quick-Release Pin

Back Cane

FIGURE 7.2 Installing Fixed Height Stroller Handles

Installing/Removing/Adjusting the Adjustable Angle Stroller Handles

NOTE: Stroller handles install in the same manner for recliner and non‐recliner models.

Installing Adjustable Angle Stroller Handles

NOTE: For this procedure, refer to FIGURE 7.3 on page 54.

1. Remove the back cane grips and plug buttons from both back canes. NOTE: Plug buttons found only on recliners.

2.Slide the adjustable height stroller handle into the back canes.

3.Align the mounting holes of the adjustable height stroller handle and the back cane.

4.Secure adjustable height stroller handle to the back canes with the two mounting screws provided. Securely tighten.

5.If necessary, adjust the height. Refer to Adjusting Adjustable Angle Stroller Handles on page 54.

Part No. 1073955 53 Orbit™