SECTION 11—RECLINER
WARNING
Before using the recliner option, make sure the
Adjustment Hole Closest
to the Ground/Floor
Most Rearward
Position
Before using ANY recline position of this wheelchair, make sure the rear wheels are in the most rearward position to maintain the stability of the wheelchair.
The seat height, seat depth, back angle, pivot point of seat frame, seating system, caster position, size and position of the rear wheels, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any combina- tion of the nine may cause the wheelchair to decrease in stability. These adjustments MUST be performed by an authorized Invacare dealer or qualified technician.
NOTE: For this procedure, refer to FIGURE 11.1 on page 72.
NOTE: Tilt and Recline Combinations:
•Recline is a term used to define the angle between the seat pan and the back.
•Tilt is a term used to define the angle between the seat pan and the ground/floor.
1.Place the wheelchair on a level surface.
2.Engage both wheel locks. Refer to Hand Activated Wheel Lock Procedures on page 66 or Foot Activated Wheel Lock Procedures on page 65.
3.Disengage the locking mechanism on the release pedal.
4.Inform the occupant of the wheelchair that the wheelchair is about to be tilted and remind them to lean back.
5.Stand behind the wheelchair and apply pressure to the release pedal.
6.Slowly, pull back on the back canes or stroller handle while stepping on the release pedal.
7.When the seat reaches the desired angle, slowly relieve the pressure on the release pedal.
8.Engage the locking mechanism on the release pedal.
9.Disengage wheel locks before attempting to move wheelchair. Refer to Hand Activated Wheel Lock Procedures on page 66 or Foot Activated Wheel Lock Procedures on page 65.
10.Recline the wheelchair if necessary. Refer to Engaging Tilt‐In‐Space on page 70.
