SECTION
4.Secure the bilateral contracture platform to the seat frame in the mounting position shown in FIGURE 5.10 with the mounting screws and washers provided. Securely tighten.
5.Adjust the bilateral contracture platform to the desired height, angle and depth. Refer to Adjusting Height of Bilateral Contracture Platform on page 36.
6.Install end caps on seat rail.
Removing Bilateral Contracture Platform
1.Remove the mounting screws and washers that secure the bilateral contracture platform to the seat frame.
2.Remove the bilateral contracture platform from the wheelchair.
3.Remove the end caps in the seat rails.
4.Install telescoping tubes. Refer to Installing/Removing/Adjusting the Telescoping Front Frame Tubes on page 38.
5.Install desired footrest. Refer to Installing/Removing Front Riggings on page 30.
Bilateral
Contracture
Washer
Seat Platform
Rail
End Cap
Upper
Support
Mounting
Screw
Locknut | Mounting |
Screw | |
| Spacers |
FIGURE 5.10 Bilateral Contracture
Platform Procedures
Adjusting Height of Bilateral Contracture Platform
NOTE: For this procedure, refer to FIGURE 5.11 on page 37.
NOTE: The bilateral contracture platform has six height adjustment options with a range of 11‐16‐inches in height.
1.Remove the mounting screw, spacers and locknut that secure the bilateral contracture platform to the upper support.
2.Slide the bilateral contracture platform up or down to the necessary height.
3.Reinstall the mounting screw, spacers, and locknuts.
4.Securely tighten the mounting screw and locknut that secure the contracture platform to the upper support. Repeat for opposite platform.
