Invacare 1073955 manual Adjusting the Quick-Release Axle, Removing/Installing Rear Wheels

Models: 1073955

1 84
Download 84 pages 54.03 Kb
Page 62
Image 62

SECTION 9—REAR WHEELS

DETAIL “A” -

 

QUICK-RELEASE

Quick-Release Axle

AXLE

Axle

Head

Bushing

Axle Mounting

End

Rear Wheel

Plate

 

 

 

Locknut

Axle Mounting Plate

DETAIL “B” -

Mounting Screw

PERMANENT Axle Bushing

AXLE

FIGURE 9.1 Removing/Installing Rear Wheels

Adjusting the Quick-Release Axle

NOTE: For this procedure, refer to FIGURE 9.2.

1.Remove rear wheel and quick‐release axle from the wheelchair. Refer to Removing/Installing Rear Wheels on page 61.

2.Depress detent pin (tip) in the quick‐release axle and slide axle through the wheel hub.

3.Release detent pin ensuring that the locking pins are fully released.

4.Increase or decrease end play by adjusting the locknut on the end of the quick‐release axle.

WARNING

Make sure the detent pin and locking pins of the quick-release axle are fully released before operating the wheelchair.

Keep locking pins clean.

5.Reinstall rear wheel onto wheelchair. Refer to Removing/Installing Rear Wheels on page 61.

Axle

MountingLocknut

Plate

Locking

Detent

Pin

Pins

 

Quick-Release Axle

Wheel Hub

FIGURE 9.2 Adjusting the Quick-Release

Axle

Orbit

62

Part No. 1073955

Page 62
Image 62
Invacare 1073955 manual Adjusting the Quick-Release Axle, Removing/Installing Rear Wheels