SECTION 6—ARMS

Installing/Removing/Adjusting Catilever Arms

NOTE: To remove, reverse this procedure.

NOTE: When removing the locknuts and washers from the cantilever arm assembly, leave the top mounting screw, coved washers and spacer (between adjustment plate and cantilever arm) in place.

1.Slide the partially assembled cantilever arm assembly with mounting hardware through the back cane. Make sure the adjustment plate is towards the inside of the wheelchair.

NOTE: This includes top mounting screw, coved washers and spacer (between adjustment plate and cantilever arm).

2.Slide the bottom mounting screw (with coved washer) through the adjustment plate and back cane.

3.Securely tighten the cantilever arm to the wheelchair with two locknuts and washers.

Adjustment

Coved

Back Cane

 

Plate

Washers

Locknuts

 

Spacer

 

Actuator

 

 

 

 

Washers

Bottom

Top Mounting Screw

Mounting

and Coved Washer

Screw

Cantilever Arm

FIGURE 6.9 Using/Installing/Adjusting Cantilever Arms

Part No. 1073955

49

Orbit

Page 49
Image 49
Invacare 1073955 manual Installing/Removing/Adjusting Catilever Arms, Using/Installing/Adjusting Cantilever Arms