SECTION
2.Rotate the arm pad 180o and reposition the arm pad on the arm tube.
3.Re‐secure the arm pad to the arm tube with the two mounting screws. Securely tighten.
4.Repeat STEPS 1‐3 for the opposite side, if necessary.
Arm Pad
Arm Tube
Mounting 
Screw
Mounting
Screw
FIGURE 6.4 Adjusting the T-Arms - Adjusting T-Arm Width
Adjusting T-Arm Depth
NOTE: For this procedure, refer to FIGURE 6.5 on page 45.
1.Remove the two mounting screws that secure the arm pad to the arm tube.
2.Remove the two mounting screws that secure the arm tube to the T‐arm post.
3.Reposition the arm tube on the T‐arm post:
A.Desk Length Arms ‐ to one of three positions depending on the desired arm pad depth.
B.Full Length Arms ‐ to one of five positions depending on the desired arm pad depth.
NOTE: Additional positions are obtainable by turning the arm tube 180o.
4.Re‐secure the arm tube to the T‐arm post with the two mounting screws. Securely tighten.
5.Reattach the arm pad to the arm tube with the two mounting screws. Securely tighten.
6.Repeat STEPS 1‐5 for the opposite side, if necessary.
