SECTION
SECTION 8—FRONT CASTERS
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise injury or damage may occur.
CAUTION
DO NOT overtighten hardware attaching to the frame. Damage to components may occur.
Replacing/Installing Front Caster Assemblies
WARNING
The seat height, seat depth, back angle, pivot point of seat frame, seating system, caster position, size and position of the rear wheels, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any combination of the nine may cause the wheelchair to decrease in stability. These adjustments MUST be performed by a qualified technician.
NOTE: For this procedure, refer to FIGURE 8.1.
1.Remove the mounting screw, spacers and locknut that secure the front caster to the fork.
2.Remove the front caster from the fork.
NOTE: If replacing a front caster on a six or eight inch front fork, note the mounting position of the existing front caster for installation of the new front caster.
NOTE: If repositioning front casters on a six or eight inch front fork, Invacare recommends that this procedure be performed by an authorized Invacare dealer or qualified technician.
3. Replace front caster and reverse STEPS 1‐ 2.
Fork |
| Locknut |
Mounting |
|
|
Screw |
| Spacer |
|
| |
Spacer |
| Front Caster |
| ||
|
|
