SECTION 5—FRONT RIGGINGS

Wheelchair Frame

Locking Pin

Sector

Mounting

Screw

Block

Washer

FIGURE 5.12 Replacing Sector Block

Installing/Removing/Adjusting the Telescoping Front Frame Tubes

NOTE: For this procedure, refer to FIGURE 5.13 on page 39.

Installing/Removing Telescoping Front Frame Tubes

1.If necessary, remove the bilateral contracture platform from the wheelchair. Refer to Bilateral Contracture Platform Procedures on page 35.

2.Insert one telescoping tube into seat rail.

3.Adjust to one of three depth positions.

4.Secure with mounting screw and locknut.

5.Repeat STEPS 2‐3 for opposite seat rail.

6.To remove, perform the following:

A.Remove the mounting screw and locknut that secures the telescoping tube to the seat rail.

B.Remove the telescoping tube from the seat rail.

Adjusting Telescoping Front Frame Tubes

1.Remove the mounting screw and locknut that secures the telescoping tube to the seat rail.

2.Adjust telescoping tube to desired depth.

3.Reinsert mounting screw and secure with locknut.

4.Repeat for opposite telescoping front frame tube.

Orbit

38

Part No. 1073955

Page 38
Image 38
Invacare 1073955 manual Installing/Removing Telescoping Front Frame Tubes, Adjusting Telescoping Front Frame Tubes