SECTION 5—FRONT RIGGINGS

Adjusting Footplate Height

NOTE: Release the footrest locking mechanism and lift the mounting pin out of the mounting tube. Lay the assembly on a flat surface to simplify this procedure.

Adjusting Pivot Slide Tube Height

NOTE: For this procedure, refer to FIGURE 5.2.

1.Remove any accessories that are attached to the footrests.

2.Remove the mounting screw and coved washer and position the footrest assembly to the desired height.

3.Align the mounting hole in the footrest support, reinsert the mounting screw and coved washer and securely tighten.

4.Repeat STEPS 1‐3 for the other footrest.

5.Reinstall any accessories attached to the footrest.

Mounting Screw

Footrest

Support

 

Coved

Washer

Footrest

FIGURE 5.2 Adjusting Footplate Height

Adjusting Footplate Height (70° MFX and 90° Footrests Only)

NOTE: For this procedure, refer to FIGURE 5.3 on page 32.

1.Remove any accessories that are attached to the footrests.

2.Remove the mounting screw, coved washer and locknut that secure the footplate to the footrest support.

3.Reposition the footplate to the desired height.

Part No. 1073955

31

Orbit

Page 31
Image 31
Invacare 1073955 manual Adjusting Footplate Height, Adjusting Pivot Slide Tube Height