Using the TV’s menu

AUTO:

The TV will automatically adjust the level of the DigiPure effect to match the amount of noise in the picture, giving the best possible picture.

MIN:

The level of DigiPure effect is set to the minimum. When you set the DigiPure Pro function to AUTO and notice some noise, change the setting from AUTO to MIN.

The MIN setting is not suitable for high-quality pictures which contain very little noise.

MAX:

The level of DigiPure effect is set to the maximum. If you set the DigiPure Pro function to AUTO but feel that the original picture quality has not been reproduced fully, change the setting from AUTO to MAX.

The MAX setting is not suitable for low-quality pictures which contain a lot of noise.

OFF:

The DigiPure Pro function is turned off.

„COLOUR SYSTEM

The AUTO function may not work properly if you have poor signal quality. If the picture is abnormal in the AUTO function, choose another colour system manually.

You cannot choose NTSC 3.58 or NTSC 4.43 for programme numbers PR 0 (AV) to PR 99.

„4:3 AUTO ASPECT

You can choose one of three ZOOM modes, REGULAR, PANORAMIC or 14:9 ZOOM, as the ZOOM mode for the normal picture (4:3 aspect ratio).

1Choose4:3PAAUTONORMICASPECT4:3 AUTO ASPECT then press the a

buttonD0017TV-REGULAR14:9ENZOOMBACKOK

ENGLISH

The colour system is chosen automatically. However, if the picture is not clear or no colour appears, choose the colour system manually.

1Choose COLOUR SYSTEM. Then press the a button

The sub-menu of the COLOUR SYSTEM function appears.

2Press the 6 buttons to choose a ZOOM mode

„PIP POSITION

You can choose one of four positions for the sub-picture.

1Press the 6buttons to choose PIP POSITION. Then press the a button

The PIP POSITION menu appears.

COLOUR SYSTEM

PIP POSITION

MAIN

SUB

PAL

AUTO

BACK

BACK

TV

OK

TV OK

D0053-EN

D0016-EN

2Press the 5 buttons to choose MAIN or SUB

MAIN:

You can change the colour system of the main-picture.

SUB:

You can change the colour system of the sub-picture.

Choose MAIN when a sub-picture is not displayed.

3Press the 6 buttons to choose the appropriate colour system. Then press the a button

PAL:

PAL system

SECAM:

SECAM system

NTSC 3.58:

NTSC 3.58 MHz system

NTSC 4.43:

NTSC 4.43 MHz system

AUTO:

This function detects a colour system from the input signal. You can only use this when you are viewing a picture from programme number PR 0 (AV), or an EXT terminal.

2Press the 5 buttons to choose the position. Then press the a button

17

Page 19
Image 19
JVC AV42PD20ES manual „ Colour System, „ 43 Auto Aspect, „ PIP Position