KitchenAid YKERI500, YKERC500 warranty Setting the clock

Using and Caring for Your Oven

Display/clock

•When you first plug in the range, a tone will sound and the display will show “88:88.” If, after you set the clock, (see the “Setting the clock” section) the display again shows “88:88,” your electricity was off for a while. Reset the clock.

•The time display will show “Err” and three short tones will sound if a time or tempera- ture is incorrectly entered.

Starting an operation

Changing audible signals

Audible signals tell you if a function is entered correctly or not. They also tell you when a cycle is completed.

To shut off audible signals during programming:

PRESS START and hold

for 4 TIME seconds

START	To shut off all signals except for the
	end-of-timer tone:
ENTER

After programming a function, you must press START/ENTER to start the function. If you do not press START/ENTER within 5 seconds of programming, “START?” will show in the display as a reminder.

Canceling an operation

CANCEL

OFF

PRESS STOP and hold

for 4 TIME seconds

To change the end-of-timer tone to a

4-second tone:

PRESS	SET
and hold	•MIN
for 4	••HR
seconds

CANCEL/OFF will cancel any function, except for the Clock Set and Kitchen Timer functions. When you press CANCEL/OFF, the large display will show the time of day.

A short tone will sound to tell you the signals have been changed. Repeat step above to turn the signals back on.

Setting the clock

1. Choose CLOCK SET.

Example:

PRESS CLOCK YOU SEE

SET

HR MIN MIN SEC

CLEAN START STOP TIME

2. Set time.

Example:				Example:
PRESS	3	3	0	YOU SEE

HR MIN MIN SEC

CLEAN START STOP TIME

3. Start clock.

PRESS START

ENTER

18

If the time has not been entered correctly, three short tones will sound and “Err” is displayed for 1 second. The previous display then reappears. Repeat Steps 1, 2, and 3 to re-enter the time of day.