Kodak 500 Function Codes

A-61408 September 1995 D-7

Function Codes The following function codes are available if the Document Printer

500 Accessory has been installed and the current application

mode allows use of the Document Printer 500 Accessory.

F40 Front and Rear Document Printers On/Off

F41 Front Document Printer On/Off

F42 Rear Document Printer On/Off

F44 Omit Printing on Next Document On/Off

Inhibits printing on the next document entering the

Feeder.

This applies to both the Front and Rear Document Print-

ers.

F45 Print Test

Refer to, Performing the Print Test Function.

F46 Front Document Printer Vertical Start Print Position

Allows the operator to change the vertical start print

position of the Front Document Printer.

F47 Rear Document Printer Vertical Start Print Position

Allows the operator to change the vertical start print

position of the Rear Document Printer.

Follow these steps to use the On/Off functions:

1. Press the F Key.

2. Press the numeric key(s) that correspond to the desired

function code.

3. Press Enter.

NOTE: If the associated accessory is not installed, an error

message will be displayed.

4. Press the numeric key 1 to turn the function ON; or press the

numeric key 0 to turn the function OFF.

5. Press Enter. (Press C to cancel the function.)

Performing the Print Test Function Function Code F45 can be used to verify the operation, vertical

start print position, and print quality of the Front and Rear Docu-

ment Printers. No other accessories (Bar Code Reader 500, Patch

Reader 500, etc.) can be enabled during the test. In addition,

scanning, Image Address increments, document counting, etc. will

not occur during this test.

To perform the print test function:

1. Press the F Key.

2. Press the numeric keys 4 and then 5.

3. Press Enter. A message will be displayed in the Status

Display indicating that the print test function is being per-

formed: Either Print Test or Feed Document(s).

4. Feed as many documents as needed to verify the operation,

position, and print quality of the information printed.

5. Press Stop.

Contents

Main Page Table of Contents Page 1 Introduction Scanner Features 1-2 A-61408 September 1995 Scanner Overview Scanner 500 Front Views Kodak Imagelink Page Page A-61408 September 1995 1-5 Control Panel Two-line Status Display Status Display Enab l e d M O DE 1 ABC/ 2 91 . 25. Operation Keys/Indicators 0 F Front 456 123+ /// // / Page Page 2 Getting Started Kodak Imagelink Enabled Scanner Operation Overview Power-up Process Calibrating the Scanner Unsuccessful Calibration Adjusting the Feed Roller and Separator Roller Page Page Adjusting the Self-Centering Feed Shelf Adjusting the Exit Hopper Page 3 Operating the Scanner Scanning Process Function Codes Using Function Codes Function Code Summary Function Code Listing Page Page Page Page Page Setting Image Levels Setting Application Modes Preparing Documents Document Sizes Kodak Imagelink Document Orientation Scanning Documents Automatic Feed Method Manual Feed Method 4 Error Messages User Actions System Administrator Actions Controlled Power-down Se- quence Controlled Power-down Sequence A-61408 September 1995 4-3 Message Listings Error Code Description Action Adjusting the Feed Roller and Separator Roller A-61408 September 1995 4-5 4-6 A-61408 September 1995 Error Code Description Action Error Code Description Action 5 Scanner Maintenance Cleaning Materials Do NOT use industrial cleaning solvents in any of the cleaning procedures. Daily (or as required) Cleaning the Imaging Guides Page Page Page Weekly (or as required) Cleaning the Feed Roller and Separator Roller Page Page Page Page Page Changing the Lamps Zum Auswechsein Der Lampen WARNING: Calibrating the Scanner. 6 Troubleshooting Clearing the Document Path Document Path Removing Documents Clearing a Jam in Area A Clearing a Jam in Area B Page Page Clearing a Jam in Area C Clearing a Jam in Area D Removing Non-Jammed Documents Appendix A Footswitch 500 Function Codes Page Appendix B Patch Reader 500 Available Patches Patch Location on Documents Printing Patches Changing the Horizontal Read Position Cleaning the Patch Reader Do not remove the Cable Tie from the Patch Reader. Function Codes Performing a Patch Test. Performing the Patch Test Function (Future Function) Appendix C Bar Code Reader 500 Use of Bar Code Information Bar Code Types Printing Bar Codes on Documents Bar Code Specifi- cations Bar Code Made Easy Function Codes Performing a Bar Code Test. Performing a Bar Code T est only when the bar code reader is installed and enabled. Kodak Bar Code Standard Test Documents. customer applica- tion documents. Bar Code Test Option 1 Evaluate Page Page Page Section 5, Scanner Maintenance B C T Y P E = C O D E 3 9 <PARTIAL> M O D = X X X % D E F = X X X % G r a d e = X R e m o v e D o c , C l o s e D o o r , P r e s s E n t e r Page Page Page Fields Displayed Bar Code Specifications Dimensional Field Values Low Bar Code Ratings Bar Code Specifi- cations Bar Code Test Option 2 Display Bar Code Test Option 3Read Rate Bar Code Specifications Page Page Appendix D Document Printer 500 Information Printed Appearance of Printed Information Page Page Page A-61408 September 1995 D-5 Hardware carriage and a Rear Document Printer 500 carriage. D-6 A-61408 September 1995 Rear Document Printer Mounting Plate Function Codes Performing the Print T est Function Cleaning and Priming the Ink Cartridge Ink deposits or spills can occur if you are not careful during the priming procedure. Front Document Printer Page Page Rear Document Printer Page Replacing the Ink Cartridge Page Page Glossary