A-61408 September 1995 2-5
6. Place one document on top of the other, hold them firmly by
their trailing edges (the edge opposite the side to be inserted
into the scanner), and insert them approximately 1/8-inch
(3 mm) into the gap.
7. If the documents do not separate, proceed to step 8. If the
documents separate, remove the documents from the feeder
and turn the Gap Adjustment Knob clockwise 1/2 turn and
insert the documents again. Repeat this step until the docu-
ments do not separate. Proceed to step 8.
8. Rotate the Gap Adjustment Knob counterclockwise 1/4 turn.
IMPORTANT:
Do not adjust the gap while documents are inthe feeder or transport systems; an inaccurateadjustment will result.9. Firmly hold the trailing edges of the documents and reinsert
the leading edges into the gap.
10. If the bottom document is not separating from the top docu-
ment, remove the documents from the feeder and repeat
steps 7 and 8 until the bottom document separates from the
top document.
11. When you have adjusted the gap so that the bottom docu-
ment separates from the top document consistently, rotate the
Gap Adjustment Knob counterclockwise another 3/4 to 1 turn
to complete the adjustment.
12. Feed a stack of 50 or 100 documents through the scanner
two times. Make sure the Count Only value on the status
display reflects the total number of documents that were fed
and that the Count Only value shows the same amount each
time the documents are fed into the scanner. This shows that
the gap is adjusted correctly.
13. Use Function Code F04 to turn off the Count Only function.