5-4 A-61408 September 1995
7. Release and remove the Front Imaging Guide by rotating the
thumb screw 90° counterclockwise, and lifting the guide’s two
saddle mounts from the scanner’s mounting shaft.
8. Release and remove the Rear Imaging Guide by swinging the
guide toward the front of the scanner (to release it from the
two magnets), and lifting the guide from the scanner’s two
mounting pins.
9. Clean both surfaces of both the Front and Rear Imaging
Guides with an antistatic wiper or a clean, soft, lint-free cloth,
slightly moistened with water or lens cleaner.
10. Dry the Imaging Guides with a dry, lint-free cloth.
11. To avoid fingerprints on the glass and area painted white,
hold the Rear Imaging Guide by the edges, and carefully set
it back into the scanner by seating it on the scanner’s mount-
ing pins. Swing the guide toward the rear of the scanner to fix
it to the two magnets.
NOTE: Look through the Upper Access Door and Side Access
Door to make sure the Imaging Guide is mounted cor-
rectly. There are two sets of pins; make sure the guide is
seated on the small, lower set of pins. When the Rear
Imaging Guide is seated correctly, the top of the guide will
sit approximately 0.5-inch (10 mm) from the Vertical
Transport Plate. The Rear Imaging Guide will become
flush with the plate when the plate is closed.
Rear Imaging Guide
Saddle Mount
Rear Imaging Guide
Mounting Pin
12. Hold the Front Imaging Guide by the edges to avoid finger-
prints on the glass and area painted white, and carefully slide
it back into the scanner by seating the guide's two green
Saddle Mounts on to the scanner's green Mounting Shaft,
and rotating the Front Imaging Guide Thumb Screw 90°
clockwise.