A-61408 September 1995 2-3
Unsuccessful Calibration If calibration fails, perform the following steps:
1. Verify that you are using a clean, matte (non-glossy), blank
sheet of paper to calibrate the scanner.
2. Make sure that length of calibration target is ≥ 12".
3. Make sure no paper is in the document path. Refer to the
section entitled,
Clearing the Document Path
.
4. Clean the imaging guides. Refer to the section entitled,
Cleaning the Imaging Guides
.
5. Calibrate the scanner again. If this calibration fails, change
the lamps. Refer to the section entitled
Changing the Lamps
.
Be sure to calibrate the scanner after changing lamps.
If calibration still fails, contact your local service representative.